Kathrein UFD 400 Manuel d'utilisateur télécharger pdf (Page 29)

Initial settings

switch the receiver off using the mains switch

on the unit

•

Set receiver 2 back into operation.

⇒

Press the

key and keep it pressed.

⇒

Using the numeric keys

... enter “

902

“.

•

To adopt the code switch receiver 2 into standby using the

key, and then

back into operation again. Set receiver 1 back into operation as well.

⇒

Press the

key and keep it pressed.

⇒

Using the numeric keys

... enter “

903

“.

Note

With the first two settings the remote control must be pointer towards the respec-

tive receiver which is switched on.

With the

key you can now switch between the two command sets A and B (tog-

gle function) and operate the two receivers in alternation.

On delivery command set 1 is always active.

Note

If you are using only one receiver and the active command set has been switched

over inadvertently due to maloperation rendering the receiver inoperable, the re-

mote control can be switched back to command set 1 without difficulty. The proce-

dure for this has already been described above.

Note

With remote control handsets that have 24 keys (remote controls of the 200-series

receivers from Kathrein) code numbers 001, 002 and 003 are to be entered in

place of codes 901, 902 and 903.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Kathrein UFD 400 Manuel d'utilisateur Page 29