Kathrein UFD 400 Manuel d'utilisateur télécharger pdf (Page 28)

Initial settings

Note

The setting is therefore to be made according to information in the “Subscriber-

controlled preprocessing system“ installation guide.

Remote frequency

If you have set "

" or “

UFO twin 1

“ in menu entry UFO mini, make the setting in

this menu entry for the transmission frequency.

The particular transmission frequency that needs to be set in the range 0 to 2150

MHz is given in the “Subscriber-controlled preprocessing system“ installation

guide”.

Note

It is therefore essential to note the installation guide instructions of the “Subscriber-

controlled preprocessing system“.

UFO micro

The setting in this menu entry is also designed for operation of the receiver on a

pre-processing system.

Here control and communication between the receiver and the Kathrein “UFO mi-

cro" system is effected via the return path of the coaxial cable.

If the UFD 400 receiver is operated on a “UFO micro“ receiving system, an “

setting must be made in menu entry “UFO micro".

A special address is then assigned to the receiver by the receiving system during

installation, so that control commands sent by the receiver to the receiving system

for signal selection will also be recognised by it.

A remote frequency does not need to be set up in this mode of operation since this

is determined by the “UFO micro" system with the addressing.

If the receiver is used on different receiving systems the previously assigned ad-

dress is to be deleted. This is done in menu entry “

Reset

As a result, the receiver is then assigned the factory-preset address once again

(virgin address). Following this, the “

" setting should be made again. The re-

ceiver is then given a new address by the new system.

Note

The pre-programming is not cleared on “Reset".

Default:

Off

•

Press the

key twice to save your settings.

•

Exit the initial setup menu with the

key (press twice).

Note

If you exit the menus without saving, the settings will be lost.

Switching over remote control’s command set

The remote control handset contains two command sets. This allows two receivers

to be operated independently in a room (not in conjunction with a twin receiver).

Note Switchover is possible for remote controls that have 24 and 26 keys.

For this purpose, programme one receiver on command set 1 and the second re-

ceiver on command set 2.

•

Switch on receiver 1. Switch off receiver 2 using the mains switch

on the

unit

⇒

Press the

key and keep it pressed.

⇒

Using the numeric keys

... enter “

901

“.

•

To adopt the code, switch receiver 1 into standby using the

key, and then

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Commentaires sur ces manuels

Pas de commentaire

Kathrein UFD 400 Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Autres dispositifs de saisie Kathrein UFD 400