Kathrein UFD 430 Manuel d'utilisateur télécharger pdf (Page 27)

Initial settings

Grundeinstellungen

In the initial setup menu, matching of the satellite receiver to the satellite receiving

system is carried out.

Important

The receiver has already been factory pre-programmed for standard satellite re-

ceiving systems.

Alterations to the initial setting are therefore necessary only if your receiving sys-

tem deviates from this type of installation or if you happen to want different set-

tings.

The settings in the initial setup menu are generally carried out by the specialist

dealer on installation of the satellite receiving system.

To prevent any unintentional alterations in the initial settings, the initial setup menu

can be invoked only from the switched-off state.

Calling the initial setup menu

•

Switch the unit into standby.

•

Press both the programme selection buttons (2)

on the receiver si-

multaneously and keep pressed.

•

Switch the unit on using the standby button on the remote control.

•

Release the

buttons when “C 38“ appears on the LED display.

C 38 is the factory preset UHF output channel. If the UHF channel has already

been altered, the appropriate channel selection appears

(between Ch. 21 and Ch. 69).

The initial setup menu is displayed.

Setting options:

Modulator: Channel 21 to 69

OSD language: 3-language German / English /French

LNB supply voltage: Off / On

LNB supply voltage in standby: Off / On

Programme selection: 1-/ 2-/ 3-figure / free entry

OSD display: Off / On (for TV and radio

separately adjustable)

Type of remote control: 26 or 24 keys.

ADR search, see separate menu

Oscillator menu: LO 1 to LO 4

DiSEqC menu:

See separate menu in section “DiSEqC"

EEPROM, see separate menu

The bottom line shows the keys you can use to make the settings.

Settings are made in the initial setup menu in the same manner as in the other

menus for the station programming:

•

Select menu entries with the

keys.

•

Carry out settings and call up submenus with the keys

(and use numeric keys .. on inputting frequencies).

•

Press the

key twice to save your settings.

•

Return with the

key.

Modulator output channel

The modulator‘s UHF output channel can be entered in the range from channel 21

to 69.

Default: channel “38“

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

Commentaires sur ces manuels

Pas de commentaire

Kathrein UFD 430 Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Autres dispositifs de saisie Kathrein UFD 430